DIGITAL BATTERY TESTER
| 5BT900
OPERATION & USE
3. Make sure the battery terminals are clean. Wire brush them if necessary.
Clamp the black load lead to the vehicle negative battery terminal. Clamp the
red load lead to the vehicle positive battery terminal. Please clamp on the lead
part of the terminal only. Clamping on the iron part of the terminal will lead to
wrong test results.
Note that nothing will be seen on the display until the tester is connected to a
vehicle battery.
PAPER REPLACEMENT
A. Open the clear cover.
B. Place a new paper roll in
the compartment.
C. Pull a short length of paper from
the compartment and press down
the clear cover to close.
To Next Page
Loading...