DIGITAL BATTERY TESTER
BT9004 |
OPERATION & USE
Note: Each time you connect the tester to a battery, the tester will run a quick cable
verication to ensure a proper connection through the output cables to sensors in the
clamp jaws. If the connection checks out OK, the tester will proceed to the Home Screen.
If the connection is poor, the display will show “CHECK CABLE”. In this case, check cable
connections for visible signs of damage, as you may need to re-connect the clamps to
the battery or replace the cable end.
1. Before you test a battery in a vehicle, turn o the ignition, all accessories and loads.
Close all the vehicle doors and the trunk lid.
2. Make sure you have put 1x CR2032 battery into the battery chamber and set the
date & time. Replace this battery if the date & time goes slower than it should be.
BEFORE TESTING
To Next Page
Loading...