59
If you cannot get a legacy ISA (Industry Standard Architecture)
expansion card to work properly, you might be able to solve
the problem by changing this item to Manual, and then open-
ing up the IRQ Resources and Memory Resources submenus.
In the IRQ Resources submenu, if you assign an IRQ Legacy
ISA, then that Interrupt Request Line is reserved for a legacy
ISA expansion card. Press <Esc> to close the IRQ Resources
submenu.
In the Memory Resources submenu, use the first item Re-
served Memory Base to set the start address of the memory
you want to reserve for the ISA expansion card. Use the sec-
ond item Reserved Memory Length to set the amount of
reserved memory. Press <Esc> to close the Memory Re-
sources submenu.
PCI/VGA Palette Snoop (Disabled)
This item is designed to overcome problems that can be
caused by some non-standard VGA cards. This board in-
cludes a built-in VGA system that does not require palette
snooping so you must leave this item disabled.
Assign IRQ for VGA/USB (Enabled)
Names the interrupt request (IRQ) line assigned to the
USB/VGA (if any) on your system. Activity of the selected IRQ
always awakens the system.
INT Pin 1 Assignment (Auto)
Names the interrupt request (IRQ) line assigned to PCI 1
through PCI 4 on your system. Activity of the selected PCI slot
awakens the system.
To Next Page
Loading...
