6
Rubber Plug
Please note:
When the tank is full the indicator will flash
and the buzzer will sound.The LCD display
will show error code H8 and the unit will
stop running.
TEMPORARY DRAINAGE
Place a suitable container under the drainage
pipe, then remove the rubber plug. Wait for
all the water to drain from the unit before
replacing the plug (Fig 1).
CAUTION:
Turn off the product and disconnect from
the mains supply.
Always ensure drainage holes are sealed
with plugs when not used.
CONTINUOUS DRAINAGE
If the unit is placed in a location allowing
continuous drainage, connect the drainage
pipe to the drainage hole (Fig 2/3), and
put the other end in a suitable drainage
location ie. outside.
Please Note: The water may be discoloured.
This is normal.
To Next Page
Loading...
