Matsui MDWTT15E - Adding Rinse Aid; Adjusting the Rinse Aid Reservoir

27
GB
Adjusting the Rinse Aid Reservoir
The rinse aid reservoir has six settings. Both the recommended setting and the factory setting is “4”. If the dishes
are not drying properly or are spotted, adjust the dial to the next higher number until your dishes are spot-free.
Adding Rinse Aid
Rinse aid helps to ensure water does not cling and leave marks on crockery during the drying phase and helps
crockery dry faster after it has been washed. Only pour rinse aid that is for domestic dishwashers into the reservoir.
This model is designed to use liquid rinse aids only.
Please follow the steps below to pour the rinse aid into the storage reservoir, and the amount will dispense
automatically.
1. Turn the cap and open as indicated.
2. When the cap open marking is aligned, you may
lift the cap up.
3. Pour the rinse aid until the rinse aid indicator turns
completely black in colour and close the cap.
4. Be careful not to overll the reservoir. Wipe up any
spills.
• If the water hardness in your area is soft, you may not need rinse aid as it may cause white lm to
develop on your dishes.
• If you decide to use a detergent tablet, you do not need to add rinse aid into the rinse aid reservoir.
• Rinse aid rell warning indicator will illuminate when the reservoir is running out of rinse aid and
requires relling.
• Alternatively, you can judge the amount of rinse aid by checking the rinse aid indicator next to the
reservoir cap. When the indicator is black, it means it is full. When it is clear, it means it is almost
empty.
If there are some rinse aid residue left in the washing compartment or your dishes, please turn the rinse
aid dispenser dial to 1.
MDWTT15E_IB_5L_150424_grace.indb 27 24/4/15 7:17 pm