EasyManua.ls Logo

Matsui MDWTT15E - Operating the Dishwasher; Starting a Wash Cycle

Matsui MDWTT15E
128 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
32
GB
Starting a Wash Cycle
1. Ensure the unit is connected to the mains power and the water supply is fully opened (water pressure between
0.04MPa and 1.00MPa).
2. Open the door. Pull out the dishwasher baskets, load the dishes and push the baskets back.
3. Pour in the detergent or place the detergent tablet in the detergent compartment and close rmly afterwards.
4. Close the dishwasher door. A click sound should be heard when the door is closed correctly. Do not slam the
door.
5. Press the Power button.
6. Select the wash cycle programme based on the loading and soil requirements. Please refer to the section Wash
Cycle Table.
7. The indicator light of the selected programme will illuminate.
8. Press the Start/Reset button, the washing cycle will begin shortly.
Changing a Programme
To change the programme if the washing cycle has already started, follow the steps below.
1. Open the door slightly to avoid water spillage before opening the door fully. Check if the unit has dispensed
the detergent or detergent tablet. This will depend on how long the washing cycle was running for.
2. If the detergent dispenser lid is opened, we suggest you to allow the wash cycle to complete.
3. If the detergent dispenser lid is still closed, press the Start/Reset button to pause the washing. Then press and
hold Start/Reset until the unit becomes standby state. Press Program again to select the new programme and
conrm the selection by pressing the Start/Reset button. The unit will start the new washing cycle shortly.
At the End of a Programme
At the end of the programme, the dishwasher will beep.
Switching O the Unit
To save energy, remember to switch the dishwasher o using the Power button. The dishwasher will continue to
use electricity unless it is switched o with the Power button.
Unloading the Dishwasher
Allowing dishes to cool down before unloading is important as dishes tend to break and chip more easily when
they are hot. Therefore, if you open the dishwasher door fully after switching o, it will allow the dishes to cool
down much faster.
If you open the dishwasher’s door during the washing cycle and then close it, the dishwasher will
continue the current washing programme after 10 seconds.
If the dishwasher is not going to be used for a long period of time, e.g. whilst on holiday, disconnect the
unit from the mains supply.
MDWTT15E_IB_5L_150424_grace.indb 32 24/4/15 7:17 pm

Table of Contents

Related product manuals