Matsui MTT667WS - Reversing the Door Swing

5
Reversing The Door Swing
Remove the plastic covering from the bottom door hinge.
Slide the Appliance door
down about 15cm [6”] and off the
Top hinge pin and lift away from the Appliance.
Place to one side.
Unscrew the three screws from the bottom bracket. Remove the
foot from opposite side.
Remove the two screws from top bracket and replace on the other
side. You will need to first remove the plastic caps from the other side.
Slide the Appliance door
back on to the Top hinge, making
sure it’s the right way up.
Screw the bottom hinge into place on the new side. Replace the
other foot on the other side. Replace the plastic covering by
clicking back into position on the door hinge.
Check that the door is aligned
horizontally and vertically and
that the seals are closed on all
sides before finally tightening
the bottom hinge.
Re-adjust the levelling feet.
• Ensure the Appliance is unplugged and empty.
• Adjust the two levelling feet to their highest position.
• We recommend you have someone to assist you.
Tools required
• Phillips style screwdriver
• Flat bladed screwdriver
3
4
5
NOTE:
To take the door off it is necessary to tilt the Appliance
backward. You should rest the Appliance on
something solid
e.g. a chair just below the top panel.
DO NOT lay the Appliance
completely flat as this may
damage the coolant system.
2
6 7
1
Fridge MTR24W/SL D1.qxd 12/9/05 5:10 PM Page 5