13
TO EDIT OR DELETE A PROGRAM SLOT
Press Menu to enter the programming menu. Select the line you want to change using
Up and Down . Press Enter .
If required, use Up and Down to change the name of the device and press Enter .
Then Press Enter to scroll through the program settings and press Up and Down to
edit times.
If you need to delete a program slot, move the cursor back to highlight the program slot
check mark and press the Up button. The check mark and settings for the program slot
will disappear to show that the program slot has been de-activated.
When you have finished programming, press Enter repeatedly to scroll through the
remaining program slots. The screen will display a large TICK to confirm that program
slot changes have been recorded.
DEVICE DESCRIPTIONS
The user has several choices for ‘Device Descriptions’ including:
POWER SAVING MODE
After 5 minutes the display will go into power saving mode, to re-activate press the
Menu key.
MANUAL ON/OFF, AND OVER-RIDE PROGRAMME
If a line is off, you can manually turn if on and off by pressing that line button. When a line
comes ON that you have programmed, you can manually turn it off by pressing that line
button. It will then come back on when it reaches its next ‘ON’ that you have programmed.
Air Pump 1
Air Pump 2
Air Pump 3
Heater 1
Heater 2
Heater 3
Filter 1
Filter 2
Filter 3
Aux 1
Aux 2
Aux 3
Feeder 1
Feeder 2
Feeder 3
<None>
Pump 1
Pump 2
Pump 3
UV 1
UV 2
UV 3
Light 1
Light 2
Light 3
PROGRAMMING (SWITCH BOX TIMER AND TIMER + PG)
To Next Page
Loading...