What to do if my Matsutec HP-33A GPS position is wrong?
If your Matsutec GPS position is incorrect, verify that the correct geodetic chart system is selected on the GPS Setting screen. Also, enter the position offset on the GPS Setting screen.
What to do if Matsutec GPS position is not fixed within 90 seconds?
If your Matsutec GPS cannot fix its position within 90 seconds, first check that the antenna connector is firmly fastened. Then, check the number of satellites on the Satellite Monitor display. If there are two or less, check for obstructions between the antenna unit and the satellites.
Why is the bearing wrong on my Matsutec HP-33A?
If the bearing on your Matsutec GPS is wrong, check the Magnetic Variation on the Plotter Setup screen.
How to fix a Matsutec HP-33A GPS that won't turn on?
If your Matsutec GPS won't turn on, check that the power cable is firmly fastened and inspect the power cable and connector for any damage. Also, make sure the volt output is over 9V; it cannot power on if it's less than 9V.
How to fix a Matsutec HP-33A when no picture appears?
If no picture appears on your Matsutec GPS, press the /BRILL key several times to adjust the brilliance.
What to do if there is no response when a key is pressed on Matsutec HP-33A GPS?
If your Matsutec GPS is not responding when a key is pressed, try turning the power off and on again. If there is still no change, ask your dealer.
Important safety warnings and precautions for users operating the device.
Crucial safety guidelines for personnel performing unit installation.
Description of the device's buttons and their functions.
Configuring the vessel's unique Maritime Mobile Service Identity.
Entering the vessel's name for AIS identification.
Adjusting collision risk parameters (CPA/TCPA) for alarms.
Methods for creating new waypoints at cursor, boat position, or via list.
Modifying existing waypoint data (position, name, shape, comment).
Step-by-step guide to creating a new route with waypoints.
Modifying routes by replacing, deleting, or inserting waypoints.
Setting a cursor location as the destination.
Designating a saved waypoint as the destination.
Selecting a predefined route as the navigation destination.
Configuring parameters for various alarm types.
Customizing plotter display settings.
Configuring GPS parameters like datum and smoothing.
Solutions for common operational issues.
Guidelines for mounting the display unit.
Recommendations for optimal antenna placement.
To Next Page
General