Mattel Mindflex - Troubleshooting Overview; Troubleshooting Connection Problems

32
TROUBLESHOOTING
TROUBLESHOOTING
CONNECTION PROBLEMS
If you receive the message “Check headset sensors,” make the following adjustments. Be sure to wait about 5 seconds
after each adjustment to see if the issue has been corrected – if so, you will hear “Calibrating headset.”
 •Makesurethesensorispressedtightandatagainstyourforehead.Adjusttheheadbandifnecessary.
 •Makesurenohairiscaughtbetweenthesensorandyourskin.
 •Movetheforeheadsensortoaslightlydifferentpositionaboveyourlefteye.
 •Removethenreattachtheclipstoyourears.
 •Makesurebothclipsarepressedatagainstyourearlobes.
 •Leavingtheheadsetonyourhead,turntheheadsetoffandbackon.
 •Cleanthesurfacesoftheforeheadandearclipsensorswithaclothorpapertowelmoistenedinwarm,soapywater.
 •Visitwww.mindflexgames.com for additional help.
NOTE: If you receive the message “Check headset sensors” during a game, the game timer will pause until you
reestablish a good connection.
When exposed to an electrostatic source, the product may malfunction and suffer memory loss. If this occurs, reset the
product by turning the console off then on.