Mauldin M415XT MAINTAINER - Machine Specifications; Drive System and Axle Specifications; Attachment Specifications

2/3/2020
Page 10 of 78
Calder Brothers Corporation
Model: M415XT Maintainer
M415XT
Section B - Specifications
SPECIFICATIONS
All Dimensions are in Inches Unless Otherwise Noted
Drive System:
Engine.............................................................. 4-cylinder, Turbocharged and after-cooled liquid cooled diesel
Tier 4 Final Compliant
Final Drive ....................................................... All Wheel Limited Slip
Hydrostatic Drive
Electronic Traction Control
Front & Rear Drive & Steering Axles
30º Front Axle Oscillation
Safety Equipment:
Neutral Start Safety Switch
Backup Alarm (noise level 84 dba w/cab) Seat Belt
SAE ROPS Certified Neutral Safety Start Switch Loader Boom Safety Prop.
Moldboard Dimensions:
Width (G) ........................................................ 120” (3.66m)
Height (H) ....................................................... 19” (.56m)
Ground Clearance (I) ....................................... 11” (.36m)
Side Shift ......................................................... 36” (.91m) left or right
Angle ............................................................... 39º right and left
Tilt Positions ................................................... Infinitely variable through 45º
Scarifier:
Tool Bar/Scarifier Width ................................. 72” (1.83m)
Maximum Tool Bar Height ............................. 24” (.61m)
Number of Shanks ........................................... 7
Shank Penetration ............................................ 8” (.20m)
Loader Assembly:
Bucket Capacity .............................................. 1/2 cubic yd/2,000 lbs (.38m
3
/.91 kg)
Dump Height (E) ............................................. 120” (3.05m)
Minimum Turning Radius:
Inside Wheel .................................................... 96” (2.44m)
Inside Moldboard ............................................ 60” (1.525m)