Calder Brothers Corporation
Model: M415XT Maintainer
M415XT
Section A - Safety
DANGER
“Danger” indicates an imminently hazardous situation which, if not
avoided, will result in death or serious injury.
WARNING
“Warning” indicates a potentially hazardous situation which, if not
avoided, could result in death or serious injury.
CAUTION
“Caution” indicates a potentially hazardous situation which, if not
avoided, may result in minor or moderate injury. May also alert against
unsafe practices.
The above Safety Alert Symbol means ATTENTION! BECOME ALERT! YOUR SAFETY IS INVOLVED! It stresses
an attitude of “Heads Up for Safety” and can be found throughout this Operator’s Manual and on the machine itself.
BEFORE YOU OPERATE THIS EQUIPMENT, READ AND STUDY THE FOLLOWING SAFETY
INFORMATION. IN ADDITION, MAKE SURE THAT EVERY INDIVIDUAL WHO OPERATES OR WORKS
WITH THIS EQUIPMENT, WHETHER FAMILY MEMBER OR EMPLOYEE, IS FAMILIAR WITH THESE
SAFETY PRECAUTIONS.
Our Company ALWAYS takes the operator and his/her safety into consideration when designing our machinery and we
guard exposed moving parts for the operator’s protection. However, some areas can NOT be guarded or shielded in order
to assure proper operation. Therefore, this Operator’s Manual, and Decals on the machine, warn of further danger and
should be read and observed closely.
ALWAYS keep this manual in a convenient place for instant reference and NEVER make repairs or adjustments that
you do not fully understand. If you require additional information or service, contact you authorized MAULDIN Dealer.
REMEMBER! It is the owner’s responsibility to communicate information on the safe use and proper maintenance of
this machine! This includes providing understandable interpretation of these instructions for operators who are not fluent
in reading English.
MANDATORY SAFETY SHUTDOWN PROCEDURE
BEFORE cleaning, adjusting, lubricating, or servicing the unit:
1.
Bring machine to full parking stop on level surface. Never park on a slope or hillside.
2.
Fully retract and lower the Moldboard and the Attachment(s) to the ground.
3.
Place controls in Neutral and set Park Brake.
4.
Idle engine for gradual cooling.
5.
Turn the Starter Key Switch to OFF position and remove key. Take the key with you for security reasons.
To Next Page
Loading...