Calder Brothers Corporation
Model: M415XT Maintainer
M415XT
Section G - Troubleshooting
PROBLEM CAUSE REMEDY
Blade Side Shift Sticks Or Stops
Dirt compacted in Blade
Slide. Cylinder damage.
Hydraulic leak. Check other
accessories for operation before
continuing work.
Clean slide.
Repair or replace.
Repair if minor. Consult an authorized
Service Dealer if major.
Jerky Operation Of Any Accessory
Damage or excessive wear on Cylinder
attachment parts.
Repair or replace.
Unit Will Not Start
(Engine Starter not operating)
Key switch inoperative.
Push Button inoperative.
Neutral Safety Switch inoperative.
Engine Starter/Solenoid inoperative.
Low battery voltage
Check for proper voltage (12 VDC).
Check for proper voltage (12 VDC).
Adjust or replace.
Refer to Engine Manual.
Charge battery.
Unit Will Not Start (Engine Starter
Operating)
No fuel in Tank.
Electric Fuel Shut-Off inoperative.
Internal fuel pump malfunction.
Internal engine problems.
Fill to proper level.
Refer to Engine Manual.
Refer to Engine Manual.
Refer to Engine Manual.
Excessive Engine Coolant
Temperature
Low coolant level.
Coolant/water ratio wrong.
Radiator air flow obstructed.
Engine fan v-belt loose.
Engine thermostat inoperative.
Water pump not working properly.
Internal engine malfunctions.
Fill to proper level.
Use engine coolant (anti-freeze).
Clean cooling fins.
Adjust.
Refer to Engine Manual.
Refer to Engine Manual.
Refer to Engine Manual.
To Next Page
Loading...