Calder Brothers Corporation
Model: M415XT Maintainer
M415XT
Section H - Service
GENERAL PRECAUTIONS
NOTE
Do NOT perform any maintenance or repair without prior authorization. Allow only trained personnel
to service the machine. In addition, WARRANTY repairs can only be done by a MAULDIN Dealer. They
will know what portions of the machine are covered under the terms of the MAULDIN warranty and what
portions are covered by other vendor OEM warranties.
NOTE
Always dispose of waste lubricating oils, anti-freeze and hydraulic fluids according to local regulations, or take
them to a recycling center for disposal. Do NOT pour them onto the ground or into a drain.
WARNING
Do NOT smoke or allow any open flames in the area while checking and/or servicing hydraulic, battery or fuel
systems. All contain highly flammable liquids or explosive gases which can cause an explosion or fire if ignited.
Keep feet, clothing, hands, and hair away from moving parts. Wear appropriate protective clothing, gloves,
and shoes.
Wear a face shield when you disassemble spring loaded components or work with battery acid. Wear a
helmet or goggles with special lenses when you weld or cut with a torch.
When working beneath a raised machine, always use blocks, jack-stands, or other rigid and stable supports.
Always wear safety glasses or goggles to protect eyes from electric arcs from shorts, fluids under pressure,
and flying debris or loose material when the Engine is running or when tools are used for grinding or
pounding.
WORK AREA PRECAUTIONS
BEFORE starting inspection and repair, move the machine onto a clean, level surface. Make sure you have
sufficient room, clearances, and adequate ventilation. Shut down Engine, and release all hydraulic pressure.
Clean walking and working surfaces. Remove oil, grease, and water to eliminate slippery areas. Use sand
or oil-absorbing compound, as necessary, while servicing the machine.
ALWAYS lower the Moldboard and Tool Bar to full ground contact. Place all controls in neutral. Block
the Wheels.
Disconnect the Battery and remove the ignition key. Remove only those guards or covers that provide
needed access. Wipe away excess grease & oil.
CAUTION
If repair welding is ever required, remove the Battery (+) positive terminal connection before proceeding to
weld. In addition, BE SURE to attach the ground (-) cable from the welder as close as possible to the area to
be repaired.
To Next Page
Loading...