Calder Brothers Corporation
Model: M415XT Maintainer
M415XT
Section H - Service
NOTE
Twist the Jumper Cable clamps a couple of times on the Battery terminals to insure a good electrical path for
conducting current.
6.
Start the machine. If it does NOT start immediately, start the jumper vehicle Engine to avoid
excessive drain on the jumper Battery.
7.
After the machine is started and running smoothly, have the second person shut the jumper
vehicle OFF. Next, that person should remove the Jumper Cables from the jumper vehicle
Battery, and then from the machine while making sure NOT to short the two cables together.
Allow sufficient time for the Alternator to build up a charge in the Battery before operating the machine or
shutting the Engine off. BE SURE to discard the cloths and re-install the Vent Caps.
NOTE
If the Battery frequently becomes discharged, have the Battery checked for possible dead cell(s) or troubleshoot
the entire electrical system for possible short circuits or damaged wire insulation.
To Next Page
Loading...