EasyManua.ls Logo

Maverick VADER XB - Specifications; Recommended Tools; Safety Precautions; Items Required for Operation

Maverick VADER XB
40 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Specifications
2
Safety precautions
This product is an authentic radio controlled vehicle (RC vehicle) and it is not a toy. Read and understand this instruction manual thoroughly
before running the model. If you are not familiar with RC vehicles, we recommend that you ask someone familiar with RC vehicles for advice.
Never connect the rechargeable drive battery in the reverse polarity or disassemble the battery. If the drive battery is used in the wrong way, high
current can be generated and it is very dangerous.
Never run RC models near people or animals, or on public streets or highways. This could cause serious accidents, personal injuries, and/or
property damage.
Recommended Tools
These tools are not included with the product but are recommended for use whilst working with this vehicle
Scissors, Mini Screwdrivers, Hexagonal Screwdrivers 1.5mm, 2.0mm, 2.5mm, 3.0mm, 4-Way Cross Wrench (Small), 4-Way Cross Wrench
(Large), Side Cutters, Needle Nose Pliers
Items required for operation
4 * AA Batteries for the Transmitter
Charging the battery pack
This vehicle does not have any batteries or chargers included.
We recommend you using 2 x 3S (11.1V) LiPo Stick pack hard cased batteries with authentic Deans Connector installed. The connectors must be
a high current type as they will get very hot whilst in use, low current connectors may melt and cause failure and possibly fire.
Always follow the manufacturers guidelines for charging of both the battery and the charger. You cannot use a Ni-MH charger with LiPo batteries
and vice versa.
Cautions
Always follow charging guidelines from the manufacturer of the battery and the charger you have.
Always use good quality high current battery connectors, we recommend genuine Deans Connectors.
Do not use the charger or battery if the wire is frayed or worn. If the wire is frayed or worn a short circuit can cause a fire or burns.
Length 710mm
Width 450mm
Height 276mm
Wheel base 503mm
Drive System 4wd Shaft Drive
Gear Ratio 11.8:1
Ground Clearance 35mm
Diameter of wheel 110mm
Width of wheel 60mm
Motor MM-27BL 980KV
Servo MS-241 20KG
Receiver MRX-242 2.4GHz 4CH
Speed Control MSC-27BL 150A Fwd/Rev

Related product manuals