automatically switch off.
b)
If unit is in the “Down” position, the thruster will auto-retract automatically before switching off.
c)
Ten seconds before system automatically switches off the unit will give an audible
warning by means of 4 short beeps.
d)
In order to isolate the power circuit of the thruster motor each time the control circuit is
switched off, it would be needed to install an electric battery isolator, as advised by Max
Power (see "Control Wiring Diagram" in the back of this manual for more detail).
e)
If power to control card was removed with system in normal operation mode (after correct
set-up procedure was followed) and with the thruster not fully up, the unit will automatically
raise as soon as power to control card is restored. The system can then be switched on
normally and will be in normal operation mode
To Next Page
Loading...
Need help?
General