10.2 Completion of the SOS emergency call
To the caller ended the call must press "1" and then press "9", the alarm routine
is completed.
In a situation where the caller ends the call by replacing the handset (without
selecting the numbers 1 and 9), the procedure alarm will continue on, and the
phone dials the next number set as an alarm.
If you want to end an emergency call, you should press the SOS on the phone or
press and hold for 3 seconds, the SOS button on the remote control
When the first emergency call number for a minute did not answer the call, your
phone will automatically be called to another emergency numbers until received.
If no number is set as an alarm, after starting the emergency call phone will only
emit a loud alarm for 15 seconds.
.
10.3 Add a contact alarm
You can select up to 5 emergency numbers. To program the numbers should be
contact in the phonebook.
Assigning emergency contact should inform the person concerned and familiar
with the procedure and receiving an SOS call termination
To add a contact SOS phone menu, select
SAVE NUMBER
Press OK / DIAL.
Use the numeric keypad to enter the number (up to 22 digits, if you make a
mistake, use the DEL key).
Press OK / DIAL
Use the numeric keypad to enter the contact name (up to 16 characters)
Press OK / DIAL
The display shows "SOS OFF, press Picture or To select "ON SOS".
Press OK / DIAL
Press Picture or to select the location
Press OK / DIAL
The contact is added to the list of emergency numbers. In the case of the
inclusion of an emergency call, first dial the number saved under "LOCATION 1",
and the last recorded under the heading "LOCATION 5"
10.4 Delete an alarm contact
To delete a contact SOS edit the contact and select "SOS OFF", see p. 18
Editing a contact from the phonebook.
To Next Page
Loading...
Need help?
General
