Maxcom KXT481SOS User Manual

ENGLISH
7
1A, 1B. Direct memory keys M1, M2
12 Key handsfree
2 Illuminating signaling an incoming call
13 switch for headphone volume +/-
3 List the number of incoming s; scroll up /
down
14 SOS button
4 LED NEW CALL-new call
15 jack of twisted cord in a base
5 CID / ESC - switching phone book / list of
incoming calls; exit from the menu
16 jack of twisted cord in a handset
cord torsion
6 del- delete character, withdrawal of the
menu
17 Switch of the ringer volume
7. MENU - Access the menu; scrolling menu
options
18 AC power
8. OK / dial-button to confirm / call the
indicated number of the incoming call list or
phone book.
19 Telephone line jack
9 Changing the FLASH
20 Adjusting the volume on the
speakerphone
10 Last number redial Redial / Pause
21 SOS button on the remote control
11 LED - line busy
22 LED testing batteries status
6 INSTALLATION
1. Location
 The telephone should be within min. 1 meter away from electrical
devices, eg. Television, radio, computer, microwave, etc.., Otherwise it
may affect their functioning
 The telephone cannot be installed in bathrooms and in areas with
high humidity
 When choosing a place should be taken into account to base has
always been within the remote SOS. The remote control SOS on the
open space is 40 meters, it can be reduced through various obstacles.
 Open the battery cover located at the bottom of the telephone.
Insert four batteries LR03 AAA 1,5V indicated
by the arrow. Batteries are required for proper
operation of the phone in the absence of power.
In the event of a power failure would be
impossible to make a call using the SOS button on the phone, or on the
remote control. Phone numbers and voice recordings are stored in non-
volatile memory and in case of battery replacement will not be deleted.
Do not use rechargeable batteries 1.2V
Close the battery cover.

Maxcom KXT481SOS Specifications

General

Brand	Maxcom
Model	KXT481SOS
Category	Telephone
Language	English