EasyManua.ls Logo

Maxi-Cosi EasyFix - Page 10

Maxi-Cosi EasyFix
122 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
GB
English
A. Installing
IMPORTANT! Make sure the Isofix connectors are retracted.
• Press the central button on the support leg (16,1) and pull the support leg forward as far as possible
(16,2).
IMPORTANT! Secure any fold-down seats.
IMPORTANT! On some seats, the belts are fitted so far forward that proper installation is not possible.
If this is the case, try another seat (see section 9: Car fitting list).
• Place the Maxi-Cosi EasyFix on the seat of the car (17) with the support leg folded out.
• Open the blue belt clamp by pulling the lever up (18,1). Pass the shoulder and lap belt together through
the belt opening (18,2).
• Pass the seat belts between the base and the blue belt clamp and then through the second belt
opening (19,1).
• Insert the seat belt into the belt buckle of the car (19,2).
NOTE! Make sure that the seat belt is pulled tight and is not twisted.
• Fasten the belt clamp by pushing the lever down (20).
• Check that it is fastened correctly by pulling on the Maxi-Cosi EasyFix.
B. Adjusting the length of the support leg
• See section 3.1, point C: “Adjusting the length of the support leg”.
Checklist …
To ensure the optimum safety of your child, check the following after installation:
• The seat belt is as tight as possible and not twisted.
• The two belt parts pass through the belt openings in the base and under the blue belt clamp.
• The support leg is fully folded out.
• The indicator at the base of the support leg is completely green.
• In some cases the Maxi-Cosi EasyFix may not be fully supported by the car seat, but entirely by the
support leg.
• The Maxi-Cosi EasyFix as a whole has been installed in the car in a secure and stable manner by pulling
on the Maxi-Cosi EasyFix.
C. Removing the Maxi-Cosi EasyFix
• Restore the support leg to its start position by pressing the control button (21,1) and sliding the support
leg upwards (21,2).
• Loosen the seat belt (22,1) and open the blue belt clamp (22,2).
22
21
20
19
19
18
17
16
14
EXI0197_GBA_EasyFix_BW_III:-- 02-10-2008 17:24 Pagina 14

Table of Contents

Related product manuals