GB
English
2. APPROVED CAR USE
The Maxi-Cosi EasyFix is approved for 2 types of car use:
Installation with Isofix and support leg (see section 3.1);
For use in cars with approved Isofix anchor points (see Section 9: Car fitting list). Recognisable by the
yellow marking on the product and the yellow marking in the instruction manual.
ór
Installation using 3-point safety belt and support leg (see section 3.2);
For use in cars “fitted” with an automatic 3-point safety belt approved in accordance with ECE R16 or
equivalent standard (see Section 9: Car fitting list). Recognisable by the blue marking on the product and
the blue marking in the instruction manual.
3. INSTALLING AND REMOVING THE MAXI-COSI EASYFIX
3.1 Using Isofix (yellow marking on the product) and support leg
If your car is equipped with Isofix anchor points, you can install the Maxi-Cosi EasyFix using the Isofix
connectors in combination with the support leg. To check whether your car is suitable for Isofix attachment
and the support leg, see Section 9: Car fitting list.
* Check car fitting list
10
• Installed on seats fitted with Isofix Yes*
anchor points (located between seat
and seat back) & with room for the
support leg
• Isofix installation marking Yellow
• Frontal airbag No
• Side airbag Yes
Isofix class E
EXI0197_GBA_EasyFix_BW_III:-- 02-10-2008 17:24 Pagina 10
To Next Page
Loading...
