Maxi-Cosi EasyFix - Using a 3-Point Safety Belt (Blue Marking on Product) and Support Leg

GB
Instructions for use
3.2 Using a 3-point safety belt (blue marking on product) and support leg
If your car is not equipped with Isofix anchor points, you can install the Maxi-Cosi EasyFix using a 3-point
safety belt in combination with the support leg. To check whether your car is suitable for installation using
a 3-point safety belt and support leg, see Section 9: Car fitting list.
* Provided there is a 3-point safety belt in the middle position of the back seat and there is enough room
for properly installing the support leg (see Section 9: Car fitting list).
Only install the Maxi-Cosi EasyFix on a forward-facing seat fitted with an automatic 3-point safety belt
approved in accordance with ECE R16 or equivalent standard.
The proper threading of the seat belt is essential to your child’s safety. The seat belt must be threaded
along the blue markings on the Maxi-Cosi EasyFix. See the sticker outlined in blue on the topside of the
Maxi-Cosi EasyFix.
Never thread the belt in any other way!
13
3
1
2
1
2
• Installation with 3-point safety belt Yes
• Installation with 2-point safety belt No
• On passenger seat Yes
• On left/right side of back seat Yes
• In middle position of back seat Yes*
• Belt routing marking Blue
• Frontal airbag No
• Side airbag Yes
EXI0197_GBA_EasyFix_BW_III:-- 02-10-2008 17:24 Pagina 13