continued on next page
5049
5
6
7
8
9
From the Back of the
Seat, Flip the Seat
Pad Forward to Reveal
Lower Anchor/UAS Belt
Remove belt and connectors
from the storage location or
if belt was used rear-facing,
remove from the Rear-Facing
Belt Path.
Thread Connectors
Through the Forward-
Facing Belt Path As
Shown
Thread the connector without
the adjuster through the
Forward-Facing Belt Path
opening on the left as shown.
Thread the connector with
the adjuster closest to it
through the Forward-Facing
Belt Path opening on the
right as shown.
Finished Lower Anchor/UAS Belt Routing
Do not twist belt.
Make Car Seat Flush
Against Vehicle Seat
Use either of the red
positions to make the car
seat as fl ush against the
vehicle seat back as possible.
Vehicle seat back must be
upright.
Do not refer to the Rear-
Facing Angle Indicator.
It does not apply to
Forward-Facing mode.
Place Car Seat
Forward-Facing in
Back Seat
Adjuster
Adjuster
Place Harness Straps
Out of the Way
Slide the buckle tongues
into the Easy-Out Harness
Holders as shown.
4
To Next Page