To Next PageTo Next Page
Need help?Do you have a question about the Maxi-Cosi Mico 30 and is the answer not in the manual?
General| Height Capacity | Up to 32 inches |
|---|---|
| Car Seat Type | Infant Car Seat |
| Harness Type | 5-point harness |
| Minimum Weight Recommendation | 5 lbs |
| Care & Cleaning | Machine washable seat pad |
| Shell Material | Plastic |
| Base Installation | LATCH |
| Base Compatibility | Compatible with Maxi-Cosi car seat base |
| Stroller Compatibility | Compatible with Maxi-Cosi strollers |
| Weight Capacity | 5 to 30 lbs |
| Safety Standards | Meets or exceeds Federal Safety Standards |
Identifies components of the child restraint as seen from the front.
Use the slot closest to your child; it should not be underneath or behind them.
Slots must be at or slightly below shoulders. If above, do not use.
Detach the infant car seat from its base using the release handle.
Align slots with lock bars and push down until it clicks to secure.
Pull the recline handle to adjust the base's angle for proper positioning.
Squeeze buttons on sides to rotate handle up or down and ensure it locks.
Spot clean harness straps with warm sudsy water and a damp cloth.
Hand wash the canopy with warm sudsy water and line dry.
Reattach the seat pad by threading straps and securing tabs.
Identifies the main components of the canopy assembly.
Detach the canopy by pressing tab locks and pulling off the hoop.
Thread the hoop through the channel and snap the plastic strips to the hubs.
Instructions for using and removing the infant head support.
Information on using and removing harness comfort covers.
Avoid front airbags, use forward-facing seats, prefer center seat.
Explains the LATCH system for installing child restraints without vehicle belts.
Using the vehicle seat belt system to install the child restraint when LATCH is not an option.
Explains switchable, automatic, and emergency locking retractors.
