English
• IMPORTANT! Check to make sure the Maxi-Cosi Mobi (XP) is securely locked in the desired position by pulling
on it.
Checklist…
To ensure the optimal safety of your child, check before every trip to make sure that…
• The entire Maxi-Cosi Mobi (XP) is installed securely and firmly in the car using the belts, tether set and car kit
(if used).
• If installed on the front seat, that the Maxi-Cosi Mobi (XP) is leaning properly against the dashboard.
• If installed on the back seat, that the Maxi-Cosi Mobi (XP) is leaning properly on the folded-out support leg.
• The height of the shoulder belts is suitable for your child.
• The belts are not twisted.
• The belt pads are positioned properly against your child’s shoulders.
• Your child is securely fastened with the harnesses, and the belt buckle is locked properly.
• The belts of the Maxi-Cosi Mobi (XP) are not damaged. If so, do not use the Maxi-Cosi Mobi (XP) under
any circumstances and contact your retailer or importer immediately.
3.3 Removing your child
• Place the Maxi-Cosi Mobi (XP) in the sitting position (also see section 3.2: Seat positions).
• Release the belt buckle by pressing the red button on the buckle (2). Drape the belts over the belt hooks
on the shell and flip away the belt buckle (3).
• Remove your child from the Maxi-Cosi Mobi (XP).
3.4 Support Pillow (Mobi XP)
Note: Only usable with the harness belt in the lowest position.
• Pull aside the bottom two flaps above the shoulder belts on one side of the cover (XP8).
• Slide one of the plastic guides on the headrest behind the top slot in the cover (XP9)
and fasten it with the round Velcro piece.
• Close the two flaps again and secure them with the Velcro strips (XP10).
• Repeat this on the other side (XP11).
4. MAINTENANCE AND CLEANING
4.1 General
• IMPORTANT! Remove the Maxi-Cosi Mobi (XP) from the car before cleaning.
• Use lukewarm water, soap and a rag to clean the plastic parts of the seat. Do not use abrasive cleaners.
• Clean the steel parts using a damp cloth.
• IMPORTANT! Never use lubricants, not even for the moving parts on the Maxi-Cosi Mobi (XP).
4.2 Seat cover
A. Removing the seat cover
• IMPORTANT! Make sure the belt buckle is locked in order to prevent the belts from twisting.
• Place the Maxi-Cosi Mobi in the sleeping position (see section 3.2: Seat positions).
• Pull the shoulder belts until the belt yoke on the back appears and remove the shoulder belts
from the belt yoke (5).
• Pull the shoulder belts out of the belt pads through the shell and cover. Do this on both sides (6).
• TIP! Loosen the top part of the cover to make it easier to remove the belts and belt pads.
• Remove the belt pads (8).
• Loosen the cover (49).
• Pull the belts, belt pads, buckle sections and belt buckle through the openings in the cover (50).
• Remove the cover.
B. Cleaning the seat cover
• The cover and belt pads should be washed by hand (maximum of 30˚C).
Do not place them in the dryer. Also see the care instructions on the cover itself.
Tip: It is advisable to buy an extra cover when purchasing the Maxi-Cosi Mobi (XP) so that you can continue
to use the Maxi-Cosi Mobi (XP) at all times, even when washing or drying the cover.
50
49
8
6
5
32
EN
14
Mobi XP
Mobi
Mobi XP
Mobi
Mobi XP
Mobi
Semibold 36 pt
Semibold Italic 36 pt
Semibold Italic 36 pt
XP8
XP9
XP10
XP11
Mobi XP
Mobi
Mobi XP
Mobi
Mobi XP
Mobi
Semibold 36 pt
Semibold Italic 36 pt
Semibold Italic 36 pt
To Next Page
Loading...
Need help?
General
