Maxitrol Selectra - Preliminary Circuit Analysis; Section I: Initial Voltage Checks; Section II: Amplifier Voltage Test; Section III: Burner Operation Test


      
faulty components, improper wiring or calibration, and other


Note:    
Section I


     

    
  





Section II
         







If proper voltages are not observed, continue testing to identify



Section III
-
Note







© 2008 Maxitrol Company, All Rights Reserved

Section IV
  -
sponding correctly, wire the system (see Figure 1 below),





       
  

If proper delivered air temperatures are observed, the prob-

      



Section V
-

OR
Model A1044U
Model A1044




