18
LIFT OPERATION SAFETY
• NEVER exceed rated capacity of 6,000-lbs.
• Tighten all Anchor Bolts prior to operation. If Anchor Bolts are
loose, or any component of the Lift is defective, do not use
the Lift.
• DO NOT remove or disable arm restraints.
• DO NOT block, open or override self-closing Lift controls; they
are designed to return to the “O” or Neutral position when
released.
• ALWAYS inspect all Quick-Connect/Disconnect Hose ends
before any attempt is made to raise vehicle.
• ALWAYS be sure to have proper overhead clearance.
• ALWAYS load vehicle on Lift carefully. Position the contact
pads according to the vehicle manufacturer’s recommended
lift points. Raise Lift until lift pads contact vehicle. Check pads
for secure contact with the vehicle.
NOTE: Refer to ALI Quick Reference Guide for all
point recommendations, dangers,and safety
data.
• ALWAYS remain clear of Lift when raising or lowering
vehicles.
• DO NOT use Lift if an unlevel lifting condition occurs that is
greater 3.5" (89 mm).
• DO NOT rock the Vehicle or remove heavy components while
on the Lift that may alter weight distribution
• ALWAYS ensure Safety Locks are engaged before any
attempt is made to work on or near Vehicle.
• NEVER go under raised vehicle if Safety Locks are not
engaged.
• ALWAYS remove tool trays, stands, etc. before lowering Lift.
• ALWAYS release Safety Locks before attempting to lower Lift.
• ALWAYS move the Lift Arms to provide an unobstructed exit
before removing Vehicle from Lift area.
• NEVER drive over the Lift Arms.
WHEN LOWERING THE LIFT PAY CAREFUL
ATTENTION THAT ALL PERSONNEL AND
OBJECTS ARE KEPT CLEAR.
ALWAYS KEEP A VISUAL LINE OF SITE ON THE
LIFT AT ALL TIMES. ALWAYS MAKE SURE THAT
ALL LOCKS ARE DISENGAGED. IF ONE OF
THE LOCKS INADVERTENTLY LOCKS UPON
DESCENT THE VEHICLE MAY DISMOUNT CAU-
SING PERSONAL INJURY OR DEATH.
VISUALLY CONFIRM THAT ALL SAFETY LOCKS
ARE ENGAGED BEFORE ENTERING WORK
AREA. SUSPENSION COMPONENTS USED
ON THIS LIFT ARE INTENDED TO RAISE AND
LOWER LIFT ONLY AND ARE NOT MEANT TO
BE LOAD HOLDING DEVICES. REMAIN CLEAR
OF ELEVATED LIFT UNLESS VISUAL CONFIR-
MATION IS MADE THAT SAFETY LOCKS ARE
FULLY ENGAGED AND THE LIFT IS LOWERED
ONTO THE SAFETY LOCKS, REFER TO OPE-
RATION MANUAL FOR PROPER SAFETY LOCK
PROCEDURES AND/OR FURTHER
INSTRUTIONS.
POST INSTALLATION CHECK OFF
Columns are properly leveled
Anchor bolts are tightened
Electric power supply conrmed
Check for hydraulic leaks
Check oil level
Lubrication of critical components
Check for overhead obstructions
Lift arms are level
Arm restraints properly adjusted
All screws, bolts, and pins are secured
Surrounding area is clear
Operation, maintenance and safety manuals on site
To Next Page
Loading...
