21
TROUBLESHOOTING GUIDE
BE SAFE: DO NOT OPERATE OR REPAIR EQUIPMENT WITHOUT READING THIS MANUAL AND
THE IMPORTANT SAFETY INSTRUCTIONS. KEEP THIS OPERATION MANUAL NEAR THE LIFT AT
ALL TIMES. MAKE SURE THAT ALL USERS READ AND UNDERSTAND THIS MANUAL.
NOTE: If your Lift is not functioning correctly, you must take it out of service.
IMPORTANT: All repair work must be done by qualied personnel.
Issue Action to Take
Lift does not go up or down. Make sure there is sucient Hydraulic Fluid in the Reservoir.
Make sure the Power Unit is connected to an appropriate power source.
Make sure there is no air in the Hydraulic System.
Make sure none of the Hydraulic Hoses are pinched or leaking.
If the Hydraulic Fluid is dirty, replace it with clean uid.
Arms move erratically or squeaks when
in use.
Move the Arms up and down a few times, with a break between each; there
could be residual air in the Hydraulic System.
Lift does not stay up. Make sure to leave the Lift engaged on both Safety Locks.
Check for Hydraulic Fluid leaks.
Vehicle on the Lift is not level. Make sure Lift is engaged on Safety Locks at the same height.
Make sure the Safety Locks in both Posts are engaged.
If the Lift is not on a Safety Lock, carefully lower the Vehicle back down to
the ground and raise it again.
Motor is not running. Check connection to power source; make sure it is plugged in to the appro-
priate voltage.
Verify circuit breaker or fuse is not tripped.
Check wiring diagram.
Lift is making odd noises when in use. Lubricate hinge points using white lithium grease.
The Lift uses electrical energy; if your organization has Lockout/Tagout policies, make sure to
implement them before performing any troubleshooting.
If you continue to have problems with your Lift, take it out of service, then contact your dealer, visit
maxjax.com/support, via email support@maxjax.com, or call (844) 629-5291.
To Next Page
Loading...
