Maxon CM10 - Frequency Bands Table; Frequency Band Selection

User Manual CM70
Page 10 of 68
Frequency Bands Table
The CM70 transceiver includes an advanced multi-standard programmable circuit, which allows the user to
program different frequency bands, specifications and operating modes (in conformity with the regulations
in the country where the product is being used). 10 programmable frequency bands are available, as per the
below table:
COUNTRY
CODE
COUNTRY
SPECIFICATIONS (CH, operating
modes, TX power)
I0 ITALY 40CH AM / FM 4W
I2 ITALY 36CH AM / FM 4W
DE GERMANY 80CH FM 4W - 12CH AM 1W
D2 GERMANY 40CH FM 4W - 12CH AM 1W
EU EUROPE 40CH FM 4W - 40CH AM 1W
CE CEPT 40CH FM 4W
SP SPAIN 40CH AM / FM 4W
FR FRANCE 40CH FM 4W - 40CH AM 1W
UK UK
40CH FM 4W UK FREQUENCIES -40CH FM 4W
CEPT FREQUENCIES
PL POLAND 40CH AM / FM 4W POLISH FREQUENCIES
Attention! This radio has been factory pre-programmed on the CE frequency band (CEPT 40CH FM 4W),
since this standard is currently accepted in all the European countries. Please refer to the information table
(Restrictions on the use of CB transceivers).
Frequency Band Selection/Programming
The radio must be programmed and used exclusively on a frequency band allowed in the country where the
product is used. It is possible to program a different frequency band, as per the following procedures:
1) Switch off the radio.
2) Press and hold the EMG key while turning on the radio, using the Power knob – Release while
all displayed icons are still lit.
3) The current country code will blink on the LCD display (2 digits).
4) Now select the desired new country code, using the
j
or
i
.
5) Shortly press the EMG key to confirm.
English
F
F
F
r
r
r
e
e
e
q
q
q
u
u
u
e
e
e
n
n
n
c
c
c
y
y
y
b
b
b
a
a
a
n
n
n
d
d
d
T
T
T
a
a
a
b
b
b
l
l
l
e
e
e