AF power.............................................5 W maximum @10% Distortion into a
4 ohm load. 4 Watts nominal.
AF frequency response ..................................Method as FTZ 17 TR 2049 July 1988
MOD Type G3.........................................Within +1/-3 dB of 6 dB/octave
de-emphasis curve
300 Hz – 2.55 kHz for 12.5 kHz
Channel Spacing
300 Hz – 3 kHz for 25 kHz
Channel Spacing
MOD Type F3 .........................................Within +1/-3 dB of 6 dB/octave
de-emphasis curve
300 Hz – 2.55 kHz for 12.5 kHz
Channel Spacing
300 Hz – 3 kHz for 25 kHz
Channel Spacing
RX Hum & Noise ......................................>40dB
RX TONE DEMODULATION CHARACTERISTICS
Subaudible tones - CTCSS/DCS
CTCSS tone range .....................................67 Hz to 250 Hz
CTCSS tone standard...................................RS-220A EIA Standard
CTCSS non-standard tones ..............................50 – 260 Hz
DCS tone standard .....................................Standard and inverted
Decode Sensitivity ......................................Method: Decrease signal level @ 10%
peak deviation
All tone ...............................................<= 9 dB SINAD
Environmental ........................................IEC529 level IP54 MIL STD 810C
EMC.................................................EMC Directive 89/336/EEC May 1989
ETS 300.279
ACCESSORIES
MA4472 Microphone
RELIABILITY ANALYSIS
Calculation method
MTBF................................................15,000 Hr. MIL-HDBK-217F. Ground
benign. Parts stress method.
MTTR ...............................................30 Min. (Average time to rework any
SMD component & reassemble).
PROGRAMMER
.....................................................SMP4004C
MAXON SM-2000 MOBILE
SPECIFICATIONS
Page-5-
December 98
To Next Page
Loading...
