24
PUSH TO
CLOSE
HOOK
4. When loading the platform
at bed level, make sure
cart stops are open (FIG.
24-1). Push load out of the
vehicle to correct position
on the platform. Place all
loads as close as possible
to the inboard edge of the
platform with heaviest part
toward the vehicle body
as shown in FIG. 24-1.
If standing on platform
with the load, stand in the
footprint area shown and
comply with the WARNING
on page 17.
Pulling the load from vehicle to platform can result in a fall from
platform and serious injury. When unloading vehicle, always
push the load out on the platform.
WARNING
!
CART STOPS CLOSED
FIG. 24-3
5. Unload platform with cart
stops at ground level as
shown in FIG. 24-3. Make
sure cart stops are closed
before moving load off the
platform. To close, push the
cart stop and hook in place
(FIG. 24-2).
CLOSING CART STOPS
(RH SIDE OF FLIPOVER)
FIG. 24-2
6. Move load off the platform
as shown in FIG. 24-3.
NOTE: Cart stops are kept
closed with a hook
(FIG. 24-2).
USING CART STOPS (IF EQUIPPED) - Continued
LOADING PLATFORM AT BED LEVEL
(DUAL CART STOPS OPEN)
FIG. 24-1
INBOARD
EDGE
VEHICLE
BODY
PLATFORM
CART STOPS
CART STOPS
To Next Page
Loading...
