MAXPEEDINGRODS MXR-3M - Unsuitable Situations and Places

HEATER STRUCTURE
04
PARKING AIR HEATER
11
1. Outer Fan Wheel
2. Fan Limit Bracket
3. Fan Motor
4. Fan Bracket
5. Inner Fan Wheel
6. Sealing Gasket
7. Combustion Chamber
8. Asbestos Gasket
9. Cylinder
10. Temperature Sensor
1 1. Controller Board
12. Controller Board Screw
Fig. 2
PARKING AIR HEATER
12
This temperature sensor is installed on the outer wall in
the middle of the heater body. If the shell temperature
exceeds 270°C, fault code E-5 is reported, and the
heater will shut down.
Overheating Sensor
LocatedintotheLCDcontroller,thetemperature
sensormeasurestheambienttemperatureattheair
inletandprovidesthedataforthemainboardwhich,
basedonthis,willcontroltheoilflowrateofthepump
fortemperatureregulation.
Temperature Sensor
1.Controller board 2.Casing 3.Heat exchanger
1.Grill 2.Casing (upper half) 3.Casing (lower half)
Fig.3 Heater Body Fig.4 Casing Structure
Close