Chapter 6
Operation Guide
◎ Please refer to Chapter 4 "Detailed Specifications" to select a suitable power
supply. To select an appropriate power supply, kindly refer to Chapter 4 "Detailed
Specifications.
◎ To ensure the peripheral working environment of the laser meets safety
requirements, consult Chapter 2 "Safety Information.
◎ Prior to laser welding, please wear the provided soundproof earplugs for your protection.
2 -
Electrical Power Connection Guidelines
1. The laser's power input line must be connected to a single-phase alternating
current (220VAC) using a 25A industrial power source.
2. It is strictly prohibited to connect the power cord directly to a household electrical
outlet.
3. Ensure that the power cord is connected to the appropriate voltage and
phase: L=220VAC, N=0VAC, and PE=ground. Verify that the wiring is correct
before operating the machine, and never neglect the PE connection.
For enhanced safety, Maxphotonics strongly recommends connecting a 32A circuit
breaker (air switch) in series between the power supply and the laser. Ideally,
position the power supply near the device's power supply unit for easy disconnection.
To Next Page
Loading...