MAXPhotonics MFP-20 User Manual

MAXPHOTONICS CO.,LTD
WWW.MAXPHOTONICS.COM
6
1.2 Accessories
Please check the included accessories according to Table 1.
Tab. 1
Items Quantity Note
Instruction
manual 1
1.3 Environment and Precautions
Power supply voltage for MFP-20 is 24±1 V DC.
WARNING:
Always use your laser device in conjunction with properly
grounded power source.
CAUTION:
Before supplying the power to the instrument, make sure that the
correct voltage of the DC power source is used (24 V). Failure to
use the correct voltage could cause damage to the instrument.
WARNING:
No operator serviceable parts inside. Refer all servicing to
qualified MAXPHOTONICS personnel. To prevent electrical
shock, do not remove covers. Any tampering with the product will
void the warranty.
WARNING:
This device has output optical head connected to the MFP-20 by
fiber cable. So please, be careful dealing with output head.
Do not
separate the fiber and the laser head.
WARNING: If this instrument is used in a manner not specified in this
document, the protection provided by the instrument may be
impaired. This product must be used only in normal conditions.
WARNING: Do not install collimator when laser is active.

MAXPhotonics MFP-20 Specifications

General

Brand	MAXPhotonics
Model	MFP-20
Category	Measuring Instruments
Language	English