26
Chapter 5
Disassembly Guide
1-Disassembly Step
The laser belongs to the precise valuables, so Maxphotonics recommends
the following steps to unpack the packing box.
Please unpack according to the following steps:
（1） Place the packing box containing the laser on a horizontal platform
such as the floor or a large table.
（2） Open the primary box and remove the foam cover.
（3） Since there is fiber on top of the laser, please carefully take it out
from the box and ensure that the maximum bending radius of the optical
armoured cable is greater than 400mm. The fiber shall be taken out under
cooperation of three employees, with two employees lifting the main body
of the laser and another employee taking out the armoured cable.
（4） Remove the form cover and take out the fittings.
（5）Check the fittings according to the ''Packing List''.
（6）Keep all objects after unpacking for future transportation or storage
needs.
CAUTION:
◎ If any damage of the external package and internal parts has been
found upon receipt of product, please contact Maxphotonics Co., Ltd. or
designated agent immediately.
To Next Page
Loading...