MAXPhotonics MFSC 1500W CW Fiber Laser Series - 4-Fiber Connector Inspection and Cleaning Guide

Chapter 6
30
7 Green
DA(0-10V) input
(positive)
analog signal,
control output power
percentage
8 Green and white
DA(0-10V) input
(negative)
9 Brown Fault output 1
Fault output 1 and 2 off
when alarm on
Fault output 1 and 2 on
when alarm off
10 Brown and white Fault output 2
11 Blue NC
12 Blue and white NC
4-Fiber Connector Inspection and Cleaning Guide
1.Tools
For cleaning a fiber connector you need the following materials:
（1） Powder-free rubber gloves or fingerstall
（2） Lint free optical cleaning wipes and/or swabs
（3）Ahydrous ethanol（Optical level, pure >99.5%）
（4）Compressed air (oil free, water free)
External Control Signal Timing
Emission Enable
Input
Laser Modulation
Input
Power Input
Red Light Signal
Output
Laser Output