28
Chapter 6
Operation Guide
1 - Notice
Caution:
◎ Please refer to Section "Detail Specification Table" for proper electrical
power.
◎ Refer to Section "General Safety Instructions" for inspecting whether
the configuration environment of peripheral work of the laser meets the
requirements.
2 -
Electrical Power Connection
A power input cord of the laser shall be connected to single-phase AC
current. Please make sure the grounding cord is perfectly connected, or
the laser may be damaged potentially.
For ensuring the safety feature, Maxphotonics recommends you connect
a 20A circuit breaker (air switch) in series between the power supply unit
and the laser. This electric power shall be in close proximity to the power
supply unit of the equipment and can be easily disconnected.
Refer to Section "Detail Specification Table" to determine your electrical
specification if you have any problem about wiring.
To Next Page
Loading...