9
Chapter 2
NOTE :
ā This device is classified as a high power Class IV laser instrument.
It may emit up to 1500W average power from 1060nm to 1100nm. This
level of light may cause damage to the eye and skin. Despite the radiation
being invisible, the beam may cause irreversible damage to the retina.
Laser safety eyewear is not provided with this instrument, but must be
worn at all times while the laser is operational. Use appropriate laser
safety eyewear when operating this device. The manufacturer of the
laser system is responsible for the safety compliance according to the
applicable standards and regulations.
2-Laser protection
1.Laser Protection Requirements
You must wear the safety protective glasses while operating the laser,
and rationally select the safety protective glasses according to the lasing
wavelength of the laser. If the device is a tunable laser or Raman product,
it emits light over a range of wavelengths and the end user should confirm
the laser safety eyewear used protects against light emitted by the device
over its entire range of wavelength.
2.Laser Protective Equipment Suppliers
Maxphotonics recommends material or equipments provided by following
laser protective equipment suppliers for you, including LaserVision USA,
Kentek Corporation, Rochwell Laser Industries, etc. All the supplier
information is provided by Maxphotonics only for the convenience to use,
so Maxphotonics assumes no responsibility for any problem caused by
using the products of abovementioned suppliers.
To Next Page
Loading...