56
Chapter 6 Operation Guide
9-Product Accessory Inspection And Cleaning Guide
1.Product accessories inspection
To clean the tip protection mirror window, you need the following equipment:
(1) Powder-free rubber gloves or finger cots
(2) Lint-free fiber cleaning cloth and cotton swab
(3) Absolute ethanol, namely alcohol (optical grade, purity >99.5%)
(4) Light source (torch or mobile phone indicator)
(5) Masking tape
(6) Microscope
NOTICE:
◎
Before using this product, please check the cleaning status and damage
degree of the protective lens. Using a dusty or damaged protective lens will
damage the welding torch head (focusing lens, extension tube, etc.) and affect
the welding effect.
◎
Unauthorized disassembly of the gun head and laser products will no longer
enjoy the warranty rights of Maxphotonics.
◎
Please wear powder-free gloves or finger cots to clean the product in a
dust-free environment. Maxphotonics will not warrant damage to the tip due to
improper operation or use of incorrect cleaning procedures.
◎
When cleaning, the concentration of absolute ethanol should be greater than
99.5%.
2.Steps
Please follow the following procedures to clean and maintain the laser welding
machine:
(1) Turn off the laser switch and cut off the power supply;
(2) Rotate the locking screw on the protective mirror housing from the gun head
and pull out to protect the mirror holder (at this time, the protective mirror drawer
is sealed with clean masking tape to prevent dust from entering), and then use
To Next Page
Loading...