2. Restore
This function allows the user to restore the firmware to its original factory version. After finish
restoring the firmware, the fixture will restart automatically and the firmware version number
will be shown.
Rotate the control dial to select “Restore”.
Press the control dial to restore the firmware.
3. Reset
This function allows the user to reset the fixture back to its factory settings. After finish
resetting the fixture, it’ll restart automatically.
Rotate the control dial to select “Reset”.
Press the control dial to factory reset the fixture.
4. Test Mode
This function allows the user to put the fixture in the test mode, which would help our
customer service representative to diagnose the fixture. This should only be done by the
users when told by authorized dealer or customer representative to perform
certain test on the fixture.
5. Model Number
This function will display the model number of the fixture, which also double serves as the ID
name when the Recurve is connected to an iOS or Android device through the Syna-G system.
Under normal circumstances this value should not be changed.
To Next Page
Loading...
Need help?
General
