ENGLISH DEUTSCH NEDERLAND FRANÇAIS ESPAÑOLITALIANO
MAX-VAC.COMMAX-VAC.COM DV 20
|
35
|
50 MBDV 20
|
35
|
50 MB
19
18
USING THE DUST BAG
Use the dust bag only
when the lter cartridge is
installed. To pick up dust of
class ‘M’ the dust bag must
be installed in the appliance.
Insert the paper lter bag in the waste
drum.
Fit the plastic ange (X) into the air inlet
connector (Y). Be careful not to damage
the bag.
Use the bag to remove dirt more
hygienically.
Dispose of the bag in compliance with the special waste disposal
regulations in force in your country
The paper bag must never be re-used but only be replaced.
CHANGING THE DUST BAG
Remove the plastic ange (1) from the air inlet connector (2).Take out the full bag.
Close the plastic ange with the cap provided.
X
Y
1
2
FOR USE AS A WET VACUUM
Always remove the lter
cartridge and the paper lter
bag, if tted. Use the foam
lter. The foam lter is not
suitable for vacuuming Class
‘M’ dust.
When the vacuumed liquids reach the
maximum level inside the drum, suction is
automatically cut off by the safety oat. The
user is alerted by an increase in the RPM
rate of the motor and the lack of suction.
Turn off the appliance immediately and
empty the drum.
VACUUMING LARGE
QUANTITIES OF LIQUID
CLEANING THE FOAM
FILTER
To ensure partial airow, make sure
that the crevice tool is never fully
submerged.
Rinse the foam lter with
water. DO NOT use detergent.
Replace if worn or torn.
To Next Page
Loading...