MaxVac DV20-MB - Troubleshooting; Eu Declaration of Conformity

ENGLISH DEUTSCH NEDERLAND FRANÇAIS ESPAÑOLITALIANO
MAX-VAC.COMMAX-VAC.COM DV 20
|
35
|
50 MBDV 20
|
35
|
50 MB
29
28
TROUBLESHOOTING
Problems Causes Solutions
The appliance will
not start
Reduced
Efciency
The RPM rate of the
motor is noticeably
higher.
The appliance will not
start in "power tool"
mode.
No power
Defective power cord,
switches or motor.
Drum too full
Filter cartridge is dirty
or caked.
Clogged tube or
accessories.
Drum too full.
Filter cartridge is dirty
or caked.
Clogged tube or
accessories.
Defective circuit board.
Check that the power
socket is working
Contact your technical
service centre (see
attached list).
Empty Drum
Thoroughly clean or
change the lter,
Check the hose or
accessories.
Check the drum.
Thoroughly clean or
change the lter,
Check the hose or
accessories.
Contact your technical
service centre (see
attached list).
Do not dispose of electrical appliances with
household waste!
In compliance with European Directive 2012/19/EU on waste electrical and
electronic equipment (WEEE) and its implementation in accordance with
national law, electric tools that have reached the end of their lifecycle must be
collected separately and returned to an environmentally compatible recycling
facility.
"EC" DECLARATION OF
CONFORMITY"
The manufacturer declares that the products described in
these instructions
MV DV20 MB | MV DV35 MB | MV DV50 MB
2014/35 / EU 2014/30 EU 2011/65 / EU
EN 60335-1: 2012 + A11: 2014
EN 60335-2-69-2012
EN 62233: 2008
EN 55014-1: 2006 + A1: 2009 + A2: 2011
EN 55014-2: 2015
EN 61000-3-2: 2014
EN 61000-3-3: 2014
Comply with the essential requisites of European Directives:
and is in accordance with standards
This declaration was drawn up in October 2016.