MaxVac DV20-MB - Power Tools

ENGLISH DEUTSCH NEDERLAND FRANÇAIS ESPAÑOLITALIANO
MAX-VAC.COMMAX-VAC.COM DV 20
|
35
|
50 MBDV 20
|
35
|
50 MB
21
20
'SELF CLEANING FILTER'
MANUAL
'SELF CLEANING FILTER' FUNCTION
With switch (B) in position “I”, when
switch (A) is set to the “AUTOMATIC”
position the Self Cleaning lter function
is activated.
When the appliance is switched off, it
will continue to run for 8/10 seconds,
then the self-cleaning lter function will
begin.
When the switch 'A' is set
to MANUAL the Self Cleaning
Filter function is not active.
If the air speed drops to below 20 m/sec., the warning light comes
on (in accordance with IEC/EN 60335-2-69)
OFF
O
N
C
B
A
Warning light (C) on:
manually start the “Self-cleaning lter”
function; press the orange switch (E).
For proper cleaning of the lter element,
follow the instructions on page 26
Continuous operation of the “Self-cleaning lter” system for more than 60
seconds may cause the thermal protection switch to trip.
FOR USE WITH POWER
TOOL
Selector switch (A): in “AUTOMATIC”
position.
Power switch (B): position “I” -
Appliance on.
The appliance runs in sync with the
power tool.
POWER TOOLS
C
B
A