Maxx MIM-50 - Page 17

16
n tube
doesn't
spray
Ice full probe
The ice full probe is
broken or can not turn
back normal position.
Repair or replace the probe
The room
temperature
The room temperature
is out the stated range,
the water pump stop
Make the temperature returns
within the stated range.
Harvesting
ice is
difficult
Hot gas valve
The hot gas valve is
poor,
Replace the hot gas valve
The hot gas valve
damage
Replace the hot gas valve
Ice mold of
the
evaporator
The ice mold is
dirty, or polishing
degree is poor.
Clean the ice mold, or replace
the evaporator.
Refrigerant
Refrigerant leaks
Recharge
Ice machine
Ice machine is not
proper leveled
Level the ice machine
The ambient
and water
temperature
The ambient and
water temperature is
too low
Adjust the temperature.
Ice cubes size
The size is too big.
See “the adjust of ice cube
size”.
The
evaporator
is hot more
than 4
minutes
Hot gas valve
The lines of the hot
gas valve loose.
Plug into again
Hot gas valve
performance poor or
break
Replace the coil of hot gas
valve if only because of the
coil.
Refrigerant
Refrigerant leaks
Recharge
Electric
controller
The electric controller
is wrong
Check the controller
The
icemaker
make an
alarm
sound
regularly
The drainage
tray on top of
the
compressor
The drainage tray on
top of the compressor
is full.
Drain off water by unscrewing
lower the drainage nut.