Troubleshooting
Before Maintenance
1. Check out the user if the user uses a 115 VAC, 60Hz. only 15ampere electrical supply, and have
properly grounded, ensure the maintainer against electrical shock.
2. Check out the leads loose? Turn off? Short circuit? If have such problems, foreclose in turn.
Basic Checking
The icemaker has some trouble, through the appearance phenomena judges. So the service
technician must check it thoroughly, then maintain.
Hearing
Hearing the user 's depiction about the icemaker at using process and the phenomena. Try to
understand what is the defect and how did the user operate the icemaker before calling for
service.
If the running sound is normal?
Looking
Check the pipe of cooling system, especially the welding point. If there is some oil, the gas is
leak out so that no ice making or less ice produced.
If the cycle of the ice making and harvest is normal?
Check the water system, especially the connection. If there is some water leakage.
Check if the water filter needs to be replaced.
Check if the icemaker installed according to the user manual.
Check if the icemaker needs to be cleaned.
Touching
Touch the hot gas pipe (with the evaporation weld), feeling the temperature. At the ice making
stage, feeling cool. At the ice harvest stage, feeling hot.
Touch the capillary tube (the drier nearby), feeling tepefaction.
Troubleshooting Guide
This troubleshooting guide in the user manual should be read before this guide. Be sure only when
the trouble shooting in user manual can’t help you solve the problem, turn to this guide.
Troubleshooting Guide
.The machine does not make ice
To Next Page
Loading...