11
ENG
Mains Cable
Plug the connector on the power cable into the corresponding plug on the treadmill. Then
connect the mains cable to an electrical socket.
The device may only be plugged-in to grounded socket which has been installed by a
professional electrician. Do not use multiple sockets to connect the treadmill. If you need
to use an extension cable, it must comply with the VDE or equivalent guidelines.
Main Switch
The main switch is located next to the power connection on the front of the treadmill. This
switch is used to turn the treadmill on or o.
Switch position “I” = treadmill switched on
Switch position “0” = treadmill switched o
Fault-Current Switch (depending on the model)
There is a fault-current button-switch next to the main switch on the front of the motor
cover to prevent the treadmill from being damaged by electrical surges in the network.
This button-switch is triggered o by if a surge in the electrical supply occurs and acts as
a circuit breaker. In this case the treadmill will be completely switched o. If this occurs,
switch o the treadmill at the main switch, and pull the mains cable out of the socket
with the plug. Press the button on the fault-current switch back in. Re-connect the mains
cable with the plug and switch the treadmill back on at the main switch.
Fuse (depending on model)
To protect the treadmill from damage caused by overvoltage of the mains there is a fuse
next to the main switch on the front of the engine cover. This breaks the circuit in the
event of an overvoltage, the treadmill is completely switched o. If this happens, turn
o the treadmill with the main power switch and unplug the power cable from the wall
socket. Check the fuse and replace if necessary. Then re-connect the power cable to the
socket and switch the treadmill back on using the main switch.
To protect the treadmill from being used by unauthorised third parties, always remove the
safety key and keep it stored away in a separate place and out of the reach of unauthor-
ised persons, such as children.
Mains Connection
May vary depending on the model
Main Switch
Mains cable
connection
Fuse
Disabling Function
Folding Mechanism
Transport
To Next Page
Loading...
Need help?
General
