Maxxus RunMAXX 90 PRO - Cockpit Advanced Functions; Quick Adjust Keys; Additional Features

13
ENG
INSTANT INCLINATION KEYS - direct access keys for incline
The cockpit of your treadmill has 4 direct access buttons for incline.
These shortcut keys allow you to quickly and easily select predened values. These can not be changed by the
user.
INSTANT SPEED KEYS - Speed selection buttons
The cockpit of your treadmill has 4 speed-dial buttons.
These shortcut keys allow you to quickly and easily select specic, predened values. These can not be
changed by the user.
INCLINE
buttons
Use these buttons to adjust the slope from level 0 to level 15 in 1-step increments.
= slope is increased
= increase is reduced
SPEED +/- buttons
Use these buttons to adjust the speed in 0.1 km / h increments.
+ = Speed is increased
- = speed is reduced
START button
Start function:
Starts the quick start function or the selected training program.
Pause function:
Pressing the START button once during exercise will stop the treadmill. The cockpit shuts o󰀨 for 5 minutes in
the pause mode. If the START button is pressed again within these 5 minutes, the training will start at the place,
where it was interrupted. After 5 minutes, the cockpit automatically performs a reset and all values are reset to
zero. When using the pause function, the training is resumed by pressing the START button again.
STOP button
Stops the current workout. If you press the STOP button twice, all values will be set to zero
VOLUME +/- buttons
With these buttons, you can adjust the volume when using a USB stick with audio les (Mp3).
+ = Volume is increased
- = volume is reduced
More functions
Hand pulse sensors
Use for short-term pulse measurement. To do this, cover the hand sensors with both hands. After a short time,
the current pulse is shown in the display. Please also read the chapter “Pulse measurement via Hand sensors
“as well as” Warnings for pulse and heart rate measurement “in this manual.
Heart Rate Receiver
The cockpit of this treadmill is factory tted with a wireless receiver for heart rate measurement. An optional
chest belt is needed. This chest belt must be on the 5 KHz frequency and uncoded. MAXXUS® recommends
the use of a POLAR® T34 transmitter chest belt. The use of Bluetooth chest straps is not possible. Please also
read the chapter “Heart Rate Measurement via Chest Belt” as well as “Warnings for pulse and heart rate meas-
urement “in this manual.
USB port
Used to connect a USB stick with audio les (MP3)
MP3 input & speaker
Used to connect an external audio source via a line-in (Aux) cable. The playback volume over the speakers can
only be regulated from the external audio source.
Cockpit