side view
2
Place air conditioner in
n
center of window. Lower
sash (window frame) to hold
cabinet in place.
top view
alternate
Caution: Check that air
conditioner cabinet is tilted to the
outside so that water will run to the
outside to avoid damage to floor
covering.
Pull curtain out until it fits
n
into the window channel.
s==JJ=!!
3
Place level on the top
1 right edge of the cabinet.
There should be a tilt to the
outside of about one-half bubble.
Place the level on the left side
and check.
Insert one of the round-head
screws through curtain and into
the window channel or through
alternate hole at the top of the
curtain and into the window
channel to fasten the curtain to
the window.
Injury Hazard
Install a window-lock bracket to
prevent air conditioner from
falling out of window.
Failure to follow this instruction
could result in serious injury.
5
Insert window rail seal
n
behind the top of the
lower window sash and against
the glass of the upper window.
Place window-lock bracket on top
of lower window and against
upper window sash. Use a 2mm
(3/32”) drill bit to drill a starter hole
through the hole in the bracket.
Attach window-lock bracket. Seal
small openings around window
with gum-type sealer.
6
Place bottom edge of
n
front panel on clips and
push down. Then push panel into
cabinet until panel snaps in place.
If your air conditioner is not
operating properly...
Check that the circuit breaker is
not tripped or house fuse blown.
Check that power supply cord is
securely plugged into the
electrical outlet.
If you need assistance...
Check your Use and Care Guide
for a toll-free number to call, or call
the dealer from whom you
purchased this appliance. The
dealer is listed in the Yellow Pages
of your phone directory under
“Appliances - Major - Service
and Repairs. II
When you call, you will need the
model number and serial number.
Both numbers can be found on the
model/serial rating label located
behind the front panel above the
coil area.
Printed in U.S.A.
Part No. 1158928 Rev. C
01995
To Previous Page