CustomerService _1_1_1_
2@EdwardsStreet, SE
Cleveland,Tennessee37311
Tel:s22-_t72-3333
Fax:423-478-6710
STEP 1
REQUIREMENTS FOR INSTALLATION
IMPORTANT SAFETY INSTRUCTIONS
This product requires a three-prong grounded receptacle. The installer must perform a ground continuity check
on the power outlet box before beginning the installation to insure that the outlet box is properly grounded. If
not properly grounded, or if the outlet box does not meet the electrical requirements note, (under ELECTRi-
CAL REQUIREMENTS), a qualified electrician should be employed to correct any deficiencies.
CAUTION: FOR PERSONAL SAFETY, REMOVE HOUSE FUSE OR OPEN CIRCUIT BREAKER
BEFORE BEGINNING INSTALLATION TO AVOID SEVERE OR FATAL SHOCK INJURY.
CAUTION: FOR PERSONAL SAFETY, THE MOUNTING SURFACE MUST BE CAPABLE OF
SUPPORTING THE CABINET LOAD, IN ADDITION TO THE ADDED WEIGHT OF THIS 65
POUND PRODUCT, PLUS ADDITIONAL OVEN LOADS OF UP TO 50 POUNDS OR A TOTAL
WEIGHT OF 115 POUNDS.
CAUTION: FOR PERSONAL SAFETY THIS PRODUCT CANNOT BE INSTALLED TO CABINET
ARRANGEMENTS SUCH AS AN ISLAND OR A PENINSULA, IT MUST BE MOUNTED TO BOTH A
TOP CABINET AND A WALL.
ELECTRICAL REQUIREMENTS
Product rating is 120 volts, AC, Hertz, 12.0 amps, and 1.35 kilowatts. This product must be connected to a
supply circuit of the proper voltage and frequency. Wire size must conform to the requirements of the
National Electric Code or the prevailing local code for this kilowatt rating. The power supply cord and plug
should be brought to a separate 15 or 20 ampere branch circuit single grounded receptacle. The outlet box
should be located near the cord entry point. The outlet box and supply circuit should be installed by a qualified
electrician and conform to the National Electric Code or the prevailing local code.
NOTE: FOR EASIER INSTALLATION AND PERSONAL SAFETY, IT IS RECOMMENDED THAT TWO
PEOPLE INSTALL THIS PRODUCT.
z
_ .MA_rAG AdmJr31 _'l =JENr, A-aa_ _'_Ji¢ C,._ef
To Next Page
Loading...
Need help?
General
