Controls at a Glance .............................................
Cycles
Heavy Wash is for
heavily soiled dish
loads.
Control panel style may vary by model.
Prewash
Prerinse
Main Wash 9.8 Gal.
Pmrinse
Hi-Temp Rinse
Dry
i........ Ju*ol i.oo,....o.l..o,.........iJ.lwi...F..o***Jll_i66 •
Prewash
Main Wash
Prerinse
Hi-Temp Rinse
Dry
Normal Wash is for
loads containing dishes
with normal amounts of
food soils.
• * woQ, • o_oo,ooolo,o m*J• eool4ao, g JQ•JooJoloool, • •
Light Wash is for
washing lightly soiled
loads.
Main Wash
Prerinse
Hi-Temp Rinse
Dry
Rinse
7.8 Gal.
5.8 Gal.
1.9Gal.
Rinse Only is for
rinsing dishes being held
until the dishwasher is
full. This helps reduce
the potential for odors.
Options
AccuTemp TM provides a water temperature check in the
main wash and also the final rinse of the cycle. If neces-
sary, the heating element will turn on and the cycle will
be extended to heat water to the proper temperature.
Select AeeuTemp'" with any cycle (except Rinse Only)
to assure proper hot water temperature and to enhance
drying results.
Note: Hot water is es_ntial for optimal cleaning and
drying results.
Pressing the Drain/Off pad once will drain the dish-
washer and then turn it off. Pressing the pad twice will
turn the dishwasher oft' without draining.
Indicator Lights
The CLEAN light is illuminated at the end of the cycle
and remains lit until the door has been open for 30 seconds
continuously.
The DRY light is illuminated during the entire dry period
and goes out when the cycle is completed.
The WASH light is illuminated during all rinse and wash
portions of the cycle
The HEATING DELAY light illuminates when the cycle
is being extended to heat the water to proper temperature.
Delay/Resume
The Delay/Resume option can be used to automatically
start the cycle at a later time, such as during off-peak
hours for reduced energy cost or to reduce daytime heat
buildup in the home.
To Set Up a Delay:
Press and hold the Delay/Resume pad until the
desired amount of delay time (2, 4 or 6 hours) is
selected. The delay time will begin counting down
when the pad is released.
Select the appropriate cycle and options for the load.
D The DELAY HOURS indicator light will remain lit
until the delay time has counted down.
D The cycle will automatically start as soon as the
delay time expires.
!
Note: If Delay/Resume is chosen without selecting a I
cycle and/or options, the dishwasher will select the last
I
cycle used. (It will not remember Rinse Only.)
Selecting the Heated Dry option improves drying results
by turning the heating element on during dry. When
Heated Dry is canceled, towel drying of some items
such as plastic and teflon may be necessary and more
moisture may be noticed on the dishwasher interior.
With either dry option it is normal to notice vapor
coming out of the vent area.
To Cancel a Delay:
Wait at least 2 seconds, then press the Delay/Resume pad
again. The indicator light will go out and the cycle will
start or resume immediately.
6
To Next Page
Loading...
Need help?
General
